The m set button for over 7 seconds manual setting mode is turned off.
How to set radio controlled wall clock.
Off by an hour or two.
1 take out the battery and place the battery in backward for about 10 seconds then replace it again in the correct position.
Confirm the correct time according to the nist atomic clock by checking their website.
Setting an atomic wall clock is simple.
Due to the nature of long wave radio signals it is normally not possible to receive a signal during the day so it is best to install the battery late in the evening.
It s best to do this late in the evening because longwave radio signals are normally not received during the day.
In north america your clock is synchronised with the atomic clock at the national institute of standards and technology in boulder colorado.
Off by minutes or seconds.
The hands stop moving and the clock starts searching for the radio signal.
There are 2 m set buttons on the back of your clock and you may use either one to force clock to search for radio signal.
Insert the correct number of fresh aa lr6 alkaline batteries in the battery compartment according to the polarity markings.
A radio controlled wall clock or atomic clock contains an atomic oscillator a radio and an antenna that enable the clock to be regularly synchronised with a true atomic clock.
You can also call 303 499 7111.
During normal run time press the rec button for 3 seconds.
Our radio controlled clocks can be manually set and used anywhere.