How to frame a non load bearing interior wall on concrete.
How to secure wall frame to concrete floor.
This will require a hefty hammer drill.
The one shown requires only a 1 4 inch hole.
Determine the wall location.
Mark the length of the new wall on both the adjoining wall and floor.
Place the fixture over the concrete and line up the holes.
Tapcon screws pre drill base plate and concrete and then secure to the floor with tapcon screwes.
First ensure the existing wall to which the new one will attach at a 90 degree angle has a stud immediately behind.
Hoist the wall frame over the bolts and set the wall frame s bottom plate on top of the sill plate.
To use it load a special gun nail and a 22 caliber gun shell into the barrel.
Place a washer and nut on each anchor bolt.
Use something impermeable to water to separate the wood from the concrete.
Line up your fixture or whatever you want to attach to the concrete.
Consult your building plans and snap a chalk line to outline the area for the stud wall with pair of lines parallel and 3 1 2 inches apart.
Measure mark and cut a 2 by 4 to serve as the bottom.
The hole in your fixture must be the same diameter of the anchor that you re bolting into the concrete.
Simply drill a hole into the concrete hold the fixture you re fastening over the hole then use a hammer to tap the anchor into the hole.
This is a short video on anchoring a wooden wall onto a concrete floor.
The fastest and easiest way to attach most wood parts to concrete is to use a powder actuated gun.
As the pin is hammered in the sleeve expands outward.
Line up the hole that you drilled into the concrete with the hole in the fixture.
Drill the hole at least 1 4 inch deeper than the length of the lower portion and vacuum or blow out the hole.
Tighten the nuts with a wrench to secure the wall frame to the foundation.
Snap chalk lines.
Align the edges and ends of the bottom plate with the edges and ends of the sill plate.
Powder actuated hammer a tool which fires a 22 caliber shell loaded with a nail.
Press the nose against the workpiece pull the trigger and the shell will drive the fastener directly into the concrete.