Paint the edges and wipe off the slop.
How to sand a 6 panel door.
Let the primer dry overnight before sanding.
Fill holes and repair imperfections with sandable filler or spackle.
Brush on the second coat following the same order and let it dry overnight.
For cracks in the door scrape or sand off any rough or raised edges.
Spread the wood filler and allow it to dry.
Take the door off the hinges and place it horizontally on sawhorses.
Lightly sand the primer with 220 grit inspecting as you go.
Before painting clean the door with a degreasing cleaner.
Sand the door again with 150 grit followed by 220 grit sandpaper.
Dust the door and wipe it down with a tack cloth.
Brush all of the sanding dust off of the door with an old soft bristle paintbrush or use a shop vac to suction it off.
For more and better information take a look.
Place a 220 grit sanding disc on the orbital sander and sand all of the flat areas again.
Dust and sand with 280 grit paper then put on the final coat.
Brush or roll paint onto all four edges.
Lightly sand the entire door.
Use 120 grit sandpaper to gently sand the door for a smoother surface that will absorb primer or paint more easily.
A couple of quick passes is all it takes.
Use a hand figuring out how to go about refinishing a pine door.
This free video diy guide provides some much need help.
It s so easy in fact that this clip can present a complete overview of the process in just over two and a half minutes time.
Back off the sandpaper and use a synthetic steel wool 3m multi flex is what i use for the raised panel and detail parts of the door.
Turn the door over and repeat all of the previous steps.
Sand the door down to bare wood with 100 grit sandpaper.
Wipe off the door with a damp rag to remove any sawdust.
The longer it dries the better it will sand.
No need to bust out the power sander you can use a sanding block or sheet of sand paper.
After sanding remove dust from the area before priming or painting.
When that s dry reattach the door hardware.
The main goal is to give your door a little tooth for the new paint or primer to adhere to.
Happily refinishing a door is easier than you might think.
Hand sand small spots or leave them and sand it while sanding your door.
Use a section of 220 grit hand sandpaper to sand the area around the raised panels.
Remove the hinges deadbolt door knob and any other hardware.